Bosch · Torque sensor
510 Bosch error code 510
Internal sensor error
Per manufacturer documentation
Note
Bosch classic system (Intuvia/Nyon/Kiox/Purion). Smart System codes differ.
Possible causes
General, component-based causes – not a manufacturer-specific statement.
- Torque sensor calibration/initialisation error
- Load on the pedal at power-up
- Sensor or cable fault
Safe test steps
- No foot on the pedal at power-up; restart.
- Mechanical condition of crank/axle.
Workshop reference values
- Do not apply universal voltage values to an unknown sensor.
Repair approach
- Manufacturer calibration procedure; persistent fault: dealer.
Tools needed
- Manufacturer dealer diagnostic tool/software (if available)
- Basic hand tools, insulated screwdrivers
Safety
- For tests with a spinning wheel use a secure work stand with the driven wheel raised.
This information does not replace manufacturer service documentation. Work on batteries and high-voltage parts only with the appropriate expertise.
Related fault codes
410One or more on-board computer buttons are blocked414Connection problem with the control unit418One or more buttons are permanently pressed419Configuration error422Connection problem with the drive unit423Connection problem with the battery424Communication error between components426Internal time-out error